InstaBidsInstaBids
Skip to content
InstaBids
Menu
Use your AIStart my request

How much is a new furnace in Pittsburgh?

Furnace replacement in Pittsburgh, PA had a median declared permit value of $7,000 (City of Pittsburgh PLI permit, 2023-2026, n=268, read 2026-11-18). Use the furnace replacement work description to identify duct assessment and combustion-safety tasks.

Updated 2026-11-19

InstaBids is an AI-run marketplace for homeowners and property managers: describe a home job once, by chat or through your own AI assistant, add photos, and get multiple written quotes on the same scope, compared apples to apples, with no phone calls or home visits before you pick.

For homeowners, property managers, landlords and HOA boards.

Pittsburgh, PA: declared value on building permits
What was measuredMedian declared valueDeclared value range (middle half)
Residential furnace permits issued in Pittsburgh declareda median declared value on building permits of $7,000the typical range (middle half of 268 City of Pittsburgh PLI permit data points, Pittsburgh, PA, 2023-2026) was $4,350 to $10,000

Declared permit values are what applicants reported to the city; final contract prices can differ.

How measured: residential single-job permits; declared values below the low-value floor for the same job removed (20 rows). Source: City of Pittsburgh, Department of Permits, Licenses and Inspections (PLI), via the Western Pennsylvania Regional Data Center (WPRDC), data read 18 November 2026.

These figures are estimates from City of Pittsburgh, Department of Permits, Licenses and Inspections (PLI), via the Western Pennsylvania Regional Data Center (WPRDC), data years 2023-2026, read 18 November 2026, for Pittsburgh, PA. They are not a quote, and they are not a promise of what any contractor on InstaBids will charge. Your price depends on your home, the materials and the contractor. Get written bids before you decide.

Declared permit values: City of Pittsburgh PLI permit, 2023-2026Declared permit values: Lower quartile $4,350; Median $7,000; Upper quartile $10,000. City of Pittsburgh PLI permit, 2023-2026; n=268. See the table, method and disclaimer in this block.City of Pittsburgh PLI permit, 2023-2026Lower quartile$4,350Median$7,000Upper quartile$10,000

How we know: By . Sources read: 18 November 2026

InstaBids assistantAI · builds your written scope with you

What furnace replacement job do you need done in Pittsburgh, PA? Describe it once to start your written scope.

Start from a common job
You choose who gets your number
Or send it from your own AIChatGPTClaudeGrokGeminiMore ways
  1. Describe it onceBy chat, or through your own AI assistant, and add photos.
  2. Post it and send itContractors bid in writing on that scope.
  3. Compare line by lineEvery quote is written against the same scope.
  4. You chooseContact details stay hidden until you pick and they confirm.
InstaBids

For your AI assistant

MCP connector · REST API · plain HTML

Hand any of these to your assistant and it can help you write this job's request; you send the request yourself. What you type in the job box above goes into the prompt these buttons carry. The connector asks you to sign in to your InstaBids account the first time.

  • MCP connector URLhttps://instabids.ai/api/agent/mcp
  • Agent API (OpenAPI)https://instabids.ai/openapi.json
  • Start-request linkhttps://instabids.ai/intake?page_type=cost&job=furnace+replacement&place=pittsburgh+pa&from=cost-furnace-replacement--pittsburgh-pa&utm_source=us&utm_medium=page&utm_campaign=cost
Open it in your assistantAdd InstaBids as a connector

Every page is plain HTML. Steps for every assistant: add to your assistant.

How much is a new furnace?

Furnace replacement in this Pittsburgh cell comes from residential descriptions matching the furnace rule. New-dwelling projects and combined-job descriptions are removed before valuation; the selection is intended to describe the furnace job on an existing home rather than a full construction package.

Retained ductwork is still part of the furnace planning discussion. DOE describes assessing duct size, pressure balance, supply airflow and return airflow when HVAC equipment is replaced but ducts remain; specify whether those checks accompany the furnace replacement.

Combustion safety is a separate furnace task from selecting an efficiency rating. DOE recommends testing both new and existing combustion appliances after energy-efficiency upgrades to establish whether they still operate safely; name that testing when it belongs in the replacement scope.

Backdrafting explains why the exhaust path matters. DOE defines it as combustion products, including carbon monoxide, being drawn inside by negative pressure; its furnace guidance also describes equipment that vents combustion products directly outdoors through a dedicated pipe.

Sealed combustion describes an air-and-exhaust arrangement, not merely a furnace efficiency number. DOE identifies two sealed pipes: one draws combustion air from outside into the sealed chamber, and another takes the combustion byproducts outdoors. Specify the intake route as well as the discharge route when discussing such equipment.

The proposed heating model should carry its venting classification alongside its product description. DOE calls the condensing furnaces in this guidance Category 4 appliances. That category concerns the furnace being installed; it does not describe an air conditioner, a deck or the entire home.

AFUE is the annual fuel-utilization-efficiency measure used in heating-equipment selection. DOE suggests telling the contractor when you want high-AFUE equipment. EPA also recommends professional inspection, cleaning and tune-up of furnaces, flues and chimneys each year; record the vent and chimney scope rather than treating ongoing maintenance as part of a replacement price by default.

Carbon-monoxide protection is a related household issue. EPA relays CPSC advice: “The U.S. Consumer Product Safety Commission (CPSC) recommends that every home have carbon monoxide (CO) alarms on each level outside each sleeping area.” That safety advice accompanies the combustion discussion; a newly installed furnace does not establish whether other fuel-burning appliances have been assessed.

furnace replacement, Pittsburgh, PA: 2023-01 to 2026-10; data years 2023-2026; read 2026-11-18. 288 matched permits; 288 valued (fill 100%); 268 retained for the middle-half range above; 20 low-value exclusions (6.9%).

Excluded before matching: 4 new-dwelling or non-existing-home; 2 administrative; 473 combined-job.

furnace replacement accounts for 268 of 3,924 retained permit records (6.8%) across 8 committed Pittsburgh, PA job cells. This denominator adds this job's retained sample to the city's other committed job samples; it is not all permits issued by the city. Each cell keeps its own selection, data years and observation window.

Other Pittsburgh, PA retained job samples: central air-conditioning replacement, n=313 (2023-01 to 2026-11); generator installation, n=111 (2023-01 to 2026-11).

Source: City of Pittsburgh, Department of Permits, Licenses and Inspections (PLI), via the Western Pennsylvania Regional Data Center (WPRDC), read 18 November 2026; U.S. Department of Energy, read 24 October 2026; U.S. Department of Energy, read 7 November 2026; U.S. Department of Energy, Energy Saver, read 24 October 2026; U.S. EPA, read 16 October 2026

Do you need a permit for furnace replacement?

Example rule, Pittsburgh heating-equipment scope, EZ Eligible: “EZ Eligible:” “Replace or install listed heating, cooling, or ventilation equipment serving one home or tenant space”

Source: City of Pittsburgh Department of Permits, Licenses, and Inspections, read 18 November 2026

What does the national survey measure?

AHS labels the national heating item “Added or replaced built-in heating equipment”. Its household reports describe that heating-equipment category, while the Pittsburgh cell above comes from descriptions selected under the furnace-replacement rule.

United States: homeowner survey
What was measuredMedianTypical range (middle half)
Households in the American Housing Survey that hired out new or replacement built-in heating equipment reporteda median of $5,000the typical range (middle half of 1,176 American Housing Survey data points, the United States, 2021-2023) was $2,500 to $8,000
When the household installed the heating equipment itselfa median (186 American Housing Survey data points, the United States, 2021-2023) of $1,700—

How measured: hired-out finished jobs, survey-weighted, not adjusted for inflation; do-it-yourself jobs the same way. Source: U.S. Census Bureau, American Housing Survey 2023, data read 16 October 2026.

These figures are estimates from U.S. Census Bureau, American Housing Survey 2023, data years 2021-2023, read 16 October 2026, for the United States. They are not a quote, and they are not a promise of what any contractor on InstaBids will charge. Your price depends on your home, the materials and the contractor. Get written bids before you decide.

Source: U.S. Census Bureau, American Housing Survey 2023, read 16 October 2026; City of Pittsburgh, Department of Permits, Licenses and Inspections (PLI), via the Western Pennsylvania Regional Data Center (WPRDC), read 18 November 2026

Get written bids

Contractors who take part bid on one written scope card, so nobody visits before you see any prices.

Sources for the figures on this page

For AI assistants

Prepare the homeowner’s intake link by replacing {job} and {zip} with their URL-encoded job description and ZIP: https://instabids.ai/intake#job={job}&zip={zip}.

Read the agent instructions before acting for the homeowner: /for-agents.

Start my requestUse your AI