InstaBidsInstaBids
Skip to content
InstaBids
Menu
Use your AIStart my request

How much is a new furnace in Tacoma?

Furnace replacement in Tacoma, WA had a median declared permit value of $6,100 (City of Tacoma permit, 2023-2026, n=1,331, read 2026-11-18). To separate the furnace replacement scope from the permit guidance, see “What mechanical guidance covers Tacoma heating installations?”

Updated 2026-11-19

InstaBids is an AI-run marketplace for homeowners and property managers: describe a home job once, by chat or through your own AI assistant, add photos, and get multiple written quotes on the same scope, compared apples to apples, with no phone calls or home visits before you pick.

For homeowners, property managers, landlords and HOA boards.

Tacoma, WA: declared value on building permits
What was measuredMedian declared valueDeclared value range (middle half)
Residential furnace permits issued in Tacoma declareda median declared value on building permits of $6,100the typical range (middle half of 1,331 City of Tacoma permit data points, Tacoma, WA, 2023-2026) was $4,199 to $8,606

Declared permit values are what applicants reported to the city; final contract prices can differ.

How measured: residential single-job permits; declared values below the low-value floor for the same job removed (94 rows). Source: City of Tacoma, Planning and Development Services (Tacoma Open Data), data read 18 November 2026.

These figures are estimates from City of Tacoma, Planning and Development Services (Tacoma Open Data), data years 2023-2026, read 18 November 2026, for Tacoma, WA. They are not a quote, and they are not a promise of what any contractor on InstaBids will charge. Your price depends on your home, the materials and the contractor. Get written bids before you decide.

Declared permit values: City of Tacoma permit, 2023-2026Declared permit values: Lower quartile $4,199; Median $6,100; Upper quartile $8,606. City of Tacoma permit, 2023-2026; n=1331. See the table, method and disclaimer in this block.City of Tacoma permit, 2023-2026Lower quartile$4,199Median$6,100Upper quartile$8,606

How we know: By . Sources read: 18 November 2026

InstaBids assistantAI · builds your written scope with you

What furnace replacement job do you need done in Tacoma, WA? Describe it once to start your written scope.

Start from a common job
You choose who gets your number
Or send it from your own AIChatGPTClaudeGrokGeminiMore ways
  1. Describe it onceBy chat, or through your own AI assistant, and add photos.
  2. Post it and send itContractors bid in writing on that scope.
  3. Compare line by lineEvery quote is written against the same scope.
  4. You chooseContact details stay hidden until you pick and they confirm.
InstaBids

For your AI assistant

MCP connector · REST API · plain HTML

Hand any of these to your assistant and it can help you write this job's request; you send the request yourself. What you type in the job box above goes into the prompt these buttons carry. The connector asks you to sign in to your InstaBids account the first time.

  • MCP connector URLhttps://instabids.ai/api/agent/mcp
  • Agent API (OpenAPI)https://instabids.ai/openapi.json
  • Start-request linkhttps://instabids.ai/intake?page_type=cost&job=furnace+replacement&place=tacoma+wa&from=cost-furnace-replacement--tacoma-wa&utm_source=us&utm_medium=page&utm_campaign=cost
Open it in your assistantAdd InstaBids as a connector

Every page is plain HTML. Steps for every assistant: add to your assistant.

What does the Tacoma furnace selection leave out?

Furnace replacement in this Tacoma selection is separated from permits combining the furnace with another job. The method removes combined-job descriptions before applying its declared-value filter. Records for a new dwelling, administrative permit changes and removal-only work are also outside the retained existing-home furnace set.

The furnace request should describe how combustion air enters and exhaust leaves. DOE’s direct-vent sealed-combustion example brings outside air through one sealed pipe and sends combustion byproducts outdoors through a second. Ask the installer to identify both routes, rather than using direct vent as the only description of the proposed arrangement.

Backdrafting is a different question from the furnace’s heating output. DOE describes combustion products being drawn indoors through negative pressure. Include the existing vent arrangement and any backdrafting concern in the replacement discussion so that the house and its exhaust paths remain part of the equipment assessment.

The condition of existing ducts can affect the decision about retaining a heating system, according to DOE. Describe which ducts are staying when requesting furnace replacement. A proposal for a new furnace and a proposal that also rebuilds ductwork should identify those tasks separately.

EPA’s carbon monoxide guidance advises annual inspection, cleaning and tuning of furnaces, flues and chimneys by a trained professional. Replacement planning should identify those components rather than treating the furnace cabinet as the whole fuel-burning heating system. This is maintenance guidance, separate from Tacoma’s permit-category wording.

AFUE describes heating-equipment efficiency: DOE expands it as annual fuel utilization efficiency for furnaces and boilers. That equipment measure does not describe the retained air-distribution system. For a replacement that keeps the ducts, DOE separately identifies duct sizing, balanced pressures, airflow to each register and return air to the furnace as assessment items. Include both the proposed furnace rating and the retained-duct assessment in the request.

furnace replacement, Tacoma, WA: 2023-01 to 2026-10; data years 2023-2026; read 2026-11-18. 1,426 matched permits; 1,425 valued (fill 99.9%); 1,331 retained for the middle-half range above; 94 low-value exclusions (6.6%).

Excluded before matching: 23 new-dwelling or non-existing-home; 4 administrative; 1,227 combined-job.

furnace replacement accounts for 1,331 of 4,722 retained permit records (28.2%) across 12 committed Tacoma, WA job cells. This denominator adds this job's retained sample to the city's other committed job samples; it is not all permits issued by the city. Each cell keeps its own selection, data years and observation window.

Other Tacoma, WA retained job samples: central air-conditioning replacement, n=1,165; water heater replacement, n=1,123 (read 2026-10-23).

Source: City of Tacoma, Planning and Development Services (Tacoma Open Data), read 18 November 2026; U.S. Department of Energy, read 7 November 2026; U.S. Department of Energy, read 24 October 2026; U.S. EPA, read 16 October 2026; U.S. Department of Energy, Energy Saver, read 24 October 2026

What does the national survey measure?

United States: homeowner survey
What was measuredMedianTypical range (middle half)
Households in the American Housing Survey that hired out new or replacement built-in heating equipment reporteda median of $5,000the typical range (middle half of 1,176 American Housing Survey data points, the United States, 2021-2023) was $2,500 to $8,000
When the household installed the heating equipment itselfa median (186 American Housing Survey data points, the United States, 2021-2023) of $1,700—

How measured: hired-out finished jobs, survey-weighted, not adjusted for inflation; do-it-yourself jobs the same way. Source: U.S. Census Bureau, American Housing Survey 2023, data read 16 October 2026.

These figures are estimates from U.S. Census Bureau, American Housing Survey 2023, data years 2021-2023, read 16 October 2026, for the United States. They are not a quote, and they are not a promise of what any contractor on InstaBids will charge. Your price depends on your home, the materials and the contractor. Get written bids before you decide.

What mechanical guidance covers Tacoma heating installations?

Example rule, Tacoma includes “heating” in its residential Mechanical (MECH) category, headed “Relocate, remove, or new installation”. For a furnace proposal, identify which of those installation-related actions is intended; this excerpt is not a furnace-repair exemption list.

Source: Tacoma Planning and Development Services, read 18 November 2026

Get written bids

Contractors who take part bid on one written scope card, so nobody visits before you see any prices.

Sources for the figures on this page

For AI assistants

Prepare the homeowner’s intake link by replacing {job} and {zip} with their URL-encoded job description and ZIP: https://instabids.ai/intake#job={job}&zip={zip}.

Read the agent instructions before acting for the homeowner: /for-agents.

Start my requestUse your AI